Would you know what to do if you get stuck on the side of the road with a flat tire? It’s better to fix it by a aerosol tire inflator, however, other people may like to fix it with the kits.
Before hitting the road, make sure you have your emergency kits. Most cars come equipped with a simple jack, lug wrench, and spare tire, but be sure to check them. Make sure the tools aren't damaged and check the tire to make sure it isn't flat. If it's been in your truck or under the car for an extensive period of time, it is possible that it has gone flat, so take a peek. If it is flat, get it fixed.
Additional tools you can keep in your trunk that will make a tire change easier and more comfortable, if you so desire, include the following:
Flashlight (with extra batteries) - This is important for other emergency situations as well.
Cushioned mat to kneel on
Changing Your Flat Tire
Turn on your hazard lights. Get the lug wrench, jack, and spare tire from the trunk and bring them over to the tire that is flat.
Loosen the lug nuts with the wrench. "Loosen" is the operative word. Don't remove the lug nuts yet; just loosen them by turning the wrench counter-clockwise. If the lug nuts are extra tight, try placing the wrench on the nut and standing on the wrench arm to use your full weight on it. Hitting the wrench arm with a rock is also an option. Note: You may need to remove the hubcap (if your tire has one) to do all this.
Lift the vehicle off the ground with the jack. Consult your owner's manual for the specific locations to place the jack as different models have different spots. Once the jack is securely in the correct spot, jack up the car until the tire is approximately 6 inches off the ground.
Remove the lug nuts and pull the tire off the car. NOW, you can remove the lug nuts. Put them all in one spot so you're not missing one when you need to put them back on. Then pull the tire straight toward yourself to remove it from the wheel base.
Place the spare on the car. Line up the lug nut posts with the holes in the spare, and push the spare all the way onto the wheel base until it can't go any farther.
Put on the lug nuts. But don't tighten them all the way.
Lower the car back to the ground. Bing the car back down to ground level using the jack and then pull the jack out from underneath the car.
Tighten the lug nuts. Now that the car is on the ground, you can now tighten the lug nuts, but don't tighten one all the way then move onto the next one. Start with one lug nut, tighten it about 50%, move to the opposite nut and tighten that one about the same amount. Keep tightening opposite lug nuts gradually in turn until each lug nut is as tight as it can be.
Put your flat tire and tools back in your trunk. Be sure you don't leave anything on the side of the road.